Balt 89855 Champ Assembly Instructions Manual - page 9
9
Insert 1 each Lock Cylinder(G) through
the Lock Plate (J) and the hole in the Large
Door Frame Tall (P-2) as shown in illustration #12.
Secure Lock Cylinder (G) using the Lock Washer (L)
and the Lock Hex (M). (F
INGER
T
IGHTEN
O
NLY
.)
Slide Lock Ring (K) and Lock Retainer (H) over the square end of Lock Cylinder (G). Secure
using the ¼” Phil Head Lock Screw (A2). Before tightening the Lock Hex (M), Insert the Key (N)
and turn lock. Be sure that Lock Retainer (H) turns 90 degrees and points up.
(T
IGHTEN
L
OCK
H
EX
(M)).
25.
Illustration # 12
Attach 1 Lower Front Trim (P-9) to the
Sliding Shelf (P-7) using 2 each Screws
(A) and 2 Dowels (E) as shown
in illustration #11.
(Tighten all Screws)
P-2
A2
G
J
H
K
N
E
A
P-14
A3
A3
P-15
26.
27.
28.
29.
P-9
A3
L
M
Attach 2 Slide Supports
(P-14) to the Sliding Shelf
(P-7) using 4 Screws (A)
and 4 Dowels (E).
(Tighten all Screws)
Illustration # 11
P-7
Attach 2 Folding Shelf Bracket (P-15) to the Side Panel (P-4) using 6 Screws (A3)
as shown in illustration #12.
Attach Sliding Shelf (P-7) to the Left
and Right Shelf Slide (P-12 & P-13)
using 4 Screws (A3) .
A3
P-4
30.