Summary of BeoLab 4000
Page 1
B e o l a b 4 0 0 0
Page 2
2 for the us-market only! Note: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful inter- ference in a residential installation. This equipme...
Page 3
3 i n t r o d u c t i o n your beolab 4000 speakers are a set of very small, active loud- speakers. Their size, style and versatility make the beolab 4000 ideal loudspeakers for all types of audio/video, surround sound and link room setups. The use of magnetically shield- ed speaker units, the sculp...
Page 4
4 b e f o r e y o u s t a r t … the beolab 4000 is designed to accomodate many place- ment alternatives and takes up very little space. In fact, it can be placed in a position which suits its surroundings and your preferred listening position. The beolab 4000 can, of course, be used in connection wi...
Page 5
5 the beolab 4000 on a level surface, e.G. A shelf or a table. To protect both your furniture and the beolab 4000 from being scratched, we recommend that you attach the enclosed rubber pads to the bottom plate of the beolab 4000 (as indi- cated on the following illustration). The beolab 4000 fastene...
Page 6
6 c o n n e c t i o n s the socket panel is located on the rear of the beolab 4000. Use this illustration and the graphics imprinted on the soc- ket panel for reference. You may connect more than one pair (as many as ten pairs, in fact) of beolab 4000 speakers to your system. You just have to run a ...
Page 7
7 connection to non-bang & olufsen products the phono socket marked line must be used instead of the power link sockets if the beo- lab 4000 is to be connected to a non-bang & olufsen product (using e.G. A cable, part no. 6270595). The signal must be on a regulated low-voltage level. Connect one spe...
Page 8
8 a b e e d d c w a l l b r a c k e t the wall bracket consists of two main parts. The bracket (a) must be secured to the wall, and the bracket (b) to the rear grille of the beolab 4000. The lock can be released by in- serting e.G. A small screwdriver through the hole (c). 1 separate the two parts (...
Page 9
9 d d b top-view of the beolab 4000 and the bracket (b). Light partition walls if you intend to hang the beo- lab 4000 on a gypsum wall, the wall bracket must be fastened to a vertical stud. If mounted in a vertical posi- tion, two screws through the holes (e) will suffice. The screws must be lag sc...
Page 10
10 d a i l y u s e switching on and off when you have finished setting up your beolab 4000, connect your entire bang & olufsen sys- tem to the mains. Turn on the power switch on each of your beolab 4000. The stand-by indicator (in the power switch button) lights up in red, indicating that the speake...
Page 11
11 m i s c l . I n f o r m a t i o n international guarantee this bang & olufsen product carries a guarantee against defects in workmanship and materials. The terms of the guarantee apply to the country of purchase but will be met by authorized bang & olufsen dealers in other countries. The guarante...
Page 12
3506220 0996 printed in denmark by bogtrykkergården a-s, struer.