Bang & Olufsen BeoLab 4000 User Manual - page 8
8
A
B
E
E
D
D
C
W A L L B R A C K E T
The wall bracket consists of two
main parts. The bracket (A)
must be secured to the wall,
and the bracket (B) to the rear
grille of the BeoLab 4000.
The lock can be released by in-
serting e.g. a small screwdriver
through the hole (C).
1 Separate the two parts (A
and B) – if necessary, loosen
the two screws (D).
2 Fasten the bracket (B), in the
preferred position, to the
BeoLab 4000.
Tighten the two screws (D)
securely!
3 Hold up the BeoLab 4000
against the wall in your se-
lected position and mark up
the outline of the bracket (B).
Use the bracket (A) as a tem-
plate to drill the holes (E).
4 Fasten the bracket (A) to the
wall through the holes (E),
and hang up the BeoLab
4000 by inserting the four
hooks into the appropriate
holes.
The lock will engage and thus
secure the two parts.
The placement of the bracket
on the rear of the BeoLab 4000
determines the angle between
the speaker and the wall.