Bang & Olufsen BeoLink Active Setting-up Manual - page 3
B E F O R E Y O U S T A R T …
Setting-up guide
This guide describes how to in-
stall your BeoLink Active kit in a
BeoLink distribution system.
If you have never carried out
cable installation before, we
suggest you leave it to your Bang
& Olufsen dealer. Likewise, we
recommend that you follow the
instructions in this guide care-
fully.
The User’s guide which is also
supplied with the BeoLink Active
kit describes how to operate your
system once it has been installed.
BeoLink system
The BeoLink distribution system
enables you to control your main
system and to hear it in the Link
room. Your Link room must be
connected to the main room via
a special (Master Link) cable. To
join the Master Link cable from
the main system and the cable
from the BeoLink Active box you
will need a Master Link junction
box. These accessories can be
purchased at your Bang & Oluf-
sen dealer.
The main room
is the room in
which you have placed your
audio system and/or video system
(the main system).
The link room
is where you are about to set up
the Beolink Active with a pair of
active speakers.
When you set up your BeoLink
Active kit, we recommend the
following sequence:
1 Switch off all products and
disconnect them from the
mains.
2 Make your installation.
3 Connect all products to the
mains.
4 Carry out the preprogramming.