Bang & Olufsen BeoLink Active Setting-up Manual - page 6
6
> Connections
In the link room:
Using a Master Link cable, connect the
multi-pin plug to the socket marked MASTER LINK on
the BeoLink Active box, and run the cable to the junc-
tion box.
Using Power Link cables (8-pin DIN), connect your ac-
tive speakers to the sockets marked POWER LINK. Re-
member to set the L • R • LINE switch on each speaker to
L and R (left and right channel), respectively.
In the main room:
Using a Master Link cable, connect the
flat multi-pin plug to the socket marked MASTER LINK
on the main system, and run the cable to the junction
box.
Inside the junction box:
Join the cables as explained in
the documentation enclosed with the box. This docu-
ment contains information of the many possibilities of
the box and how to join the cables.
Connect one speaker to the
socket marked Power Link and
then loop the signals through to
the other speaker as described
in the User’s guide for your
speakers.
*The socket marked PC is used in
BeoLink PC setups only. Please
refer to the User’s guide enclosed
with the BeoLink PC kit.
Main System
Master Link con-
nection
to the main system
Link System
Junction box
PC*
BeoLink Active box