Bang & Olufsen BeoSound 1 Manual - page 11
11
The BeoSound 1 has a built-in 24
hour clock. You must set the clock
yourself.
If you want to make use of the
Wake-up Timer function described
on the next page, you must first
make sure that the built-in clock in
the BeoSound 1 has been set
correctly. If BeoSound 1 has been
disconnected from the mains for
approximately 30 minutes, the clock
must be set again.
Set the right time
Set the built-in clock
You must set the built-in clock manually while
BeoSound 1 is in standby.
See the stored time
The stored time can be shown briefly in the
display.
While BeoSound 1 is in standby,
press
ss
and
tt
simultaneously
and hold until the time is shown
in the display. Both the digits
and the dot are blinking
If no time is set, the display will
show lines instead of digits
Press
ss
or
tt
to find the correct
time. Holding down
ss
or
tt
will
accelerate the change in
numbers
Press STORE to store the correct
time. The time is briefly shown
in the display
ss
tt
20.00
--,--
ss
tt
14.25
STORE
15.00
Press both
ss
and
tt
shortly. The
time is shown briefly in the
display, the dot is blinking
While BeoSound 1 is in standby,
press the STANDBY button to
see the time in the display
ss
tt
14.25
STANDBY
14.25
NOTE! Pressing the red button on the Beo4
remote control will show the time in the display