Bang & Olufsen BeoSound 5 User Manual - page 15
Make basic settings
Follow the on-screen
instructions
Activate a BeoSound 5
source
Connect BeoMaster 5 to the
mains supply
Settings For further information about Settings, refer to the Guide on
www.bang-olufsen.com/guides.
The supplied mains cord and plug are specially designed for the product.
If you change the plug or damage the mains cord, you must buy another
from your Bang & Olufsen retailer.
Secure the cables …
1. Insert the cables (VIDEO, USB and POWER) into
the corresponding sockets in the base of the music
system. Note: Place a cable binder behind the USB
plug (A).
2. Run the USB cable through the cable holder.
3. Run the POWER cable under the USB cable and
over the VIDEO cable, and then through the cable
holder.
4. Run the VIDEO cable under the USB and POWER
cables, and then through the cable holder. Finally,
to secure the cables, tighten the cable binder (A).
…
NOTE! See the BeoMaster Guide for information
about the connections.
The music system can only be switched off
completely by disconnecting the BeoMaster from
the mains.
Mount CD-Rip
For instructions on how to mount the
optional CD Ripping Device together with
your music system, see the instructions
enclosed with the CD Ripping Device.
Note that it should be mounted by
a Bang & Olufsen retailer.
VIDEO
POWER
USB
A
USB
POWER
VIDEO
A
15