Bang & Olufsen BeoVision Avant Setup Manual - page 10
10
BeoVision Avant allows you to play
DVDs, video CDs and audio CDs. All
operation of the DVD player, apart
from loading and unloading of a
DVD, is done via the Beo4 remote
control. Loading is done via the
LOAD button on top of the
television.
The DVD player’s on-screen tool bar
gives you access to additional
functions, such as camera angle or
subtitles as well as changing
chapters, etc., if these are available
on your disc. The tool bar informs
you of the current settings for these
functions as well.
Use the DVD player
Load and play
Loading a disc in the DVD player is done via
the LOAD button on the close-up operation
panel on BeoVision Avant, just above the
television screen.
The DVD loader will close automatically when
you turn off the television.
*NOTE! For further instructions in the use of the
close-up operations panel, refer to the chapter
Close-up operation in the Reference book on
page 58.
LOAD
DVD
From the close-up operation panel…
> Press LOAD to open the DVD loader. The display
window prompts you to load a disc.
> Place a disc in the loader.
> Press LOAD and the loader closes.
> Press DVD to start playback of the disc*.
If the DVD player can not recognise the format of
a loaded disc, the disc is ejected and DVD LOAD is
shown in the display window. This may be due to
disc faults such as dust, dirt, fingerprints or
scratches. Refer to ‘Maintenance of your BeoVision
Avant’ on page 60 in the Reference book for more
information about handling DVDs.