Banks six-gun Owner's manual - 10.
10
96505 v.6.0
9.
Locate the rubber grommet on the
driver’s side of the vehicle firewall.
The grommet is about 3” in diameter.
Make a 1” x 1” cross-shaped incision
in the grommet (see Figure 6).
10.
Now from inside the cab locate
the grommet on the firewall and make
another 1” x 1” cross-shaped incision
on the grommet. Feed the three-
connector cable through the incision
made in the firewall grommet and into
the cab.
11.
With the Six-Gun Diesel Tuner
positioned on top of the fuse box,
peel the protective backing from the
hook and loop interlocking fasteners
attached to the Six-Gun Diesel Tuner.
Position the side edge of the Six-Gun
Diesel Tuner to the edge closest to the
engine of the fuse cover, then press
the adhesive onto the outside of the
fuse box cover. Apply light pressure to
the Six-Gun Diesel Tuner by hand for
60-seconds to create a strong bond
between the fuse box and hook &
loop interlocking fasteners. Using the
supplied cable ties, secure the wire
harness away from any heat sources
or moving components.
Note: Make sure the fuse box cover
is clean and free of any oil residue and
contaminates. Clean fuse box cover
with a non-oil based solvent such as
Acetone, Mineral Spirits, Denatured
Alcohol or Lacquer thinner. Read and
follow the manufactures operation
instruction for non-oil based solvent
cleaner.
WARNING: Make sure to place the
tuner as shown in Figure 2 to avoid
a clearance issue when closing the
hood. Mount the Six-Gun Tuner as
close to the inside edge of the fuse
cover as possible.
-END, SECTION 1-
Figure 5