Banks six-gun Owner's manual - Section 2
12
96505 v.6.0
If not installing the optional Banks
PowerPDA, skip to Section 3.
NoTE: This system has been
designed for use with the Palm
Tungsten E2 PDA.
WARNING: The PDA may be
susceptible to damage as a result
of extended exposure to sunlight,
heat or extreme cold. It is highly
recommended that the PDA
be removed from its mounting
location if the vehicle will be
subjected to high concentrations
of sunlight, heat or cold for
an extended period of time.
Gale Banks Engineering is not
responsible for damage to PDAs
resulting from exposure conditions.
1.
Locate the universal mount and
docking station in your kit. Interlock
the docking station to the universal
mount by inserting and sliding the
universal mount tabs into the docking
station grooves. See Figure 7.
2.
Find a smooth, flat surface suitable
for ease of access and viewing
of the PowerPDA. Loosen both knobs
and move the swivel suction plate and
docking station to achieve desired
viewing angle of the PowerPDA
screen. Do a test fit and note the
angle necessary to achieve the correct
viewing angle.
Note: there may be a snug fit when
installing the PowerPDA into the
docking station. take care not to force
this process.
3.
Tighten both knobs to lock in the
position (Figure 7).
Note: If the universal mount swivel
does not move or is tight after
loosening the hold down knob, then
remove the previously inserted
docking station and slightly loosen the
tension screw. See Figure 9.
Section 2
MOUNTING THE DOCkING STATION AND CONNECTING THE BANkS
POWERPDA VEHICLE COMMAND CENTER
Figure 7