Bantam e-STATION 902 Operating Manual - page 10
Display
LiPo Dischg
2.0A 11.1V(3S)
+
-
+
-
Display
Li3S DSC 0010mAh
8.21V 0.5A 12m
Discharging the Lithium battery
'>3 seconds'
current
voltage of
the battery
discharge
current
discharged
capacity
calculated
time
Display
LiPo Cycle
CHG>DSCH 3
◀
+
-
Display
C>D 1 0200mAh
16.23V 3.0A 12m
Charge-to-discharge & discharge-to-charge cycle Lithium battery
present
battery
voltage
charge or
discharge
current
charged or
discharged
capacity
elapsed
time
+
-
Set the sequence on the left and the number of cycling
on the right. You can use this function for balancing,
refreshing and breaking-in the battery. To avoid rising
temperature of the battery, there will a brief cool-off
period that already fixed at 'user setting' after each
charge and discharge process. The cycling number
ranges from 1 to 5.
To stop the process, press key once. You can
change the discharge current by pressing key
once during the process. The audible sound indicates
you the end of process.
Display
DSCH 1 1314mAh
CHG 1 1430mAh
At the end of the process, you can see charged or
discharged electric capacities of the battery at each
cyclic process.
By pressing or button the screen shows
the result of each cycle in order.
Batt type
Stop
DEC
◀
INC
▶
Start/
Enter
DEC
◀
INC
▶
Batt type
Stop
DEC
◀
INC
▶
Start/
Enter
◀
DEC
◀
INC
▶
The value of discharge current on the left side of screen
may not exceed 1C for a maximum safety and the final
voltage on the right should not be under the voltage
level that is recommended by the battery manufacturer
to avoid deep discharging.
To start to discharge press key for more than 3
seconds.
This shows the present state of discharge. To stop
discharging press key once.
Start
Enter
Batt type
Stop
Batt type
Stop
Start
Enter
DEC
◀
I N C▶
- 10 -
'>3 seconds'