Bantam e-STATION 902 Operating Manual - Warning and Error Messages
The output is connected to a battery with incorrect polarity.
This will be displayed in case of detecting an interruption of the
connection between battery and output or voluntarily
disconnecting the charge lead during the operation of charge or
discharge on output.
If the charger can not proceed the operation anymore because
of malfunction of the circuit.
The charge process has been started even the voltage was
selected erroneously, because of deep-discharged or
over-charged Lithium battery. Please adjust the 'check time' at
users setting or check you battery carefully.
The voltage of input power lowers the limit.
The voltage of Lithium battery pack was selected incorrectly.
Verify the voltage of battery pack carefully.
Display
Reversed Polarity
Display
Connection Break
Display
Input Vol Err
Display
Break Down
Display
Display
Vol Select Err
Display
Battery Check....
Over Voltage
The voltage of Lithium battery pack was selected incorrectly.
Verify the voltage of battery pack carefully.
Display
Control Failure
Display
Lipo Series Err
No: xxS ??.00V
Display
Temp Over Err
Display
Out-2 Polarity
Err
If the charger can not proceed the operation anymore because
of malfunction of the circuit.
Battery Check....
Low Voltage
Warning and error messages
902 incorporates a various functions of protective and monitoring system programmed to verify
functions and to monitor the state of its electronics. In any case of occurring error, the screen
displays the cause of error that is self-explanatory with audible sound.
In case of balance mode charging, the voltage of one of the cell
in the Lithium battery pack dropped below the limit, or the
pin-assignment of battery pack was wrong. The charger will
terminate charging process automatically for safety reason.
The 'OUTPUT-2' output is connected to a battery with incorrect
polarity.
- 19 -
The internal temperature of the unit goes too high. Cool down the
unit.