Bantam e-STATION 902 Operating Manual - page 14
Display
OUTPUT-2 Charge
current 2.0A
Display
OUT-2 CHG 0090mAh
5.70V 2.0A 12m
Charging at 'OUTPUT-2' / Electric motor drive
battery
voltage
charging
current
charged
capacity
collapsed
time
This program can charge the battery at 'OUTPUT-2' regardless of operating 'OUTPUT-1'. At
'OUTPUT-2', you can charge NiCd or NiMH battery up to 8 cells with the maximum charge current
of 2.0A. This program also employs the delta-peak voltage detection method to terminate charging
process. (Do not attempt to charge Lithium battery at 'OUTPUT-2')
You also can selected program to run your new electric motor for break-in procedure at
'OUTPUT-1'. Or you can test your electric power plant to set up an optimum condition. The break-in
procedure is essential for upgrading the power of a new motor.
To set up the parameter value in the program, press key to make it blink then change the
value with or key. The value will be stored by pressing key once.
Display
Program Select
OUT-2/
Motor
Set up the charge current of 'OUTPUT-2'.
The charge current ranges from 0.1 to 2.0A.
The screen shows the present state of 'OUTPUT-2'.
The charge process starts on connecting the battery
to the 'OUTPUT-2' charge lead automatically,
regardless of operating 'OUTPUT-1'. And the screen
will be returned to the 'OUTPUT-1' mode after 10
seconds automatically.
+
-
* Even though the charge current of 'OUTPUT-2' was fixed previously, you can change it during the
process. To do this press button more than 3 seconds to display 'OUTPUT-2' screen again.
Then press button once to blink the charge current field to alter the value using or
buttons. Press button once again to continue the process with the charge current that has
been caged.
Display
Motor break-in
2.0V 30min
Display
Drive 0089mAh
2.07V 1.8A 2.9W
Connect the motor to the output lead from 'OUTPUT-1'
output. Set up the drive voltage and time. To start the
motor run, press button for more than 3 seconds.
(voltage: 1.0 ~ 15V, run time: 1 ~ 60min)
The screen shows the present state of motor running.
To stop the procedure, press button once.
+
-
+
-
driving
voltage
current consumption output power
'> 3 seconds'
DEC
◀
INC
▶
Start/
Enter
Start/
Enter
DEC
◀
INC
▶
DEC
◀
INC
▶
Start/
Enter
Start
Enter
DEC
◀
I N C▶
Start
Enter
Start
Enter
Start
Enter
Start
Enter
DEC
◀
I N C▶
Start
Enter
Batt type
Stop
- 14 -