Baofeng UV-82 User Manual - page 73
(send comments, suggestions or corrections to UV-82@KC9HI.net)
Long Name / Description / Settings / Notes
Global
Reference for UV-82 Menus
by Jim Unroe - KC9HI
11-January-2014
Menu Number
/ Short Name
MR/
Channel
Mode
VFO/
Frequency
Mode
Separate
VFO
A & B
Settings
Stored
on a Per
Channel
Basis
Band Selection
RO
✓
✓
✓
In VFO/Frequency mode, sets [A] or [B] to the VHF or UHF band.
Settings: VHF[0] | UHF[1]
Default: VHF
Note:
Dual Watch / Dual Reception Display Priority
✓
Settings: OFF[0] | A[1] | B[2]
Default: OFF
Note: Requires menu 7 to be enabled
Squelch Tail Elimination - Transceiver
✓
Settings: OFF[0] | ON[1]
Default: ON
Note: Set to OFF before communicating through a repeater.
Note: Recommended setting is OFF
Squelch Tail Elimination - Repeater
✓
This function is used eliminate squelch tail noise when communicating through a repeater.
Settings: OFF[0] | 1 - 10
Default: 5
Note: Requires use of a repeater utilizing this feature.
Note: Used with menu 37
Note: Recommended setting is OFF
Delay the Tail Tone of Repeater (X100 milliseconds)
✓
Settings: OFF[0] | 1 - 10
Default: OFF
Note: Used with menu 36
Note: Recommended setting is OFF
Boot Display
✓
Controls the behavior of the display when the transceiver is turned on.
Settings: FULL[0] | MSG[1]
Default: FULL
FULL: Performs an LCD screen test at power-on
MSG: Displays a 2-line power-on message
Note: The power-on message must be edited with software
Roger Beep
✓
Settings: OFF[0] | ON[1]
Default: OFF
Note: Recommended setting is OFF
Roger Beep – End of Reception
✓
Settings: OFF[0] | A[1] | B[2]
Default: OFF
Note: Useful when menu 7 is set to ON
Restore to Default Settings
✓
Settings: VFO[0] | ALL[1]
Default: ALL
VFO:
ALL:
33
BAND
When transitioning from VHF to UHF or from UHF to VHF, the
selected band's low frequency limit becomes the displayed frequency
(the original 'scratch' frequency is lost)
34
TDR-AB
When enabled, priority is returned to selected display once the signal in the other display
disappears.
35
STE
This function is used eliminate squelch tail noise between UV-5Rs that are communicating
directly (no repeater). A short duration 50Hz tone is transmitted when the PTT key is
released.
36
RP-STE
37
RPT-RL
38
PONMSG
39
ROGER
Sends an end-of-transmission tone to indicate to other stations that the transmission has
ended.
40
A/B-BP
Emits an end-of-reception tone in the speaker when squelch closes on the selected
display.
41
RESET
Resets all menus to firmware default and sets the [A] and [B] VFO
frequencies to firmware default.
Resets all menus to firmware default, sets the [A] VFO frequency to
the VHF band low limit and the [B] VFO frequency to the UHF band
low limit, erases all channels and programs channel 0 to 136.025
MHz and channel 127 to 470.625 MHz