- DL manuals
- Baofeng
- Transceiver
- UV-82
- Operating Manual
Baofeng UV-82 Operating Manual
Summary of UV-82
Page 1
Dual band/dual display radio uv-82 o perating m anual.
Page 2
Preface thank you for purchasing uv-82 portable radio, which is a dual band/dual display radio. This easy-to-use radio will deliver you secure, instant and reliable communications at peak efficiency. Please read this manual carefully before use. The information presented herein will help you to deri...
Page 3
Content 1.safety information 2.features and functions 3.unpacking and checking equipments 4. optional accessories 5. installation of accessories 5.1. installing the antenna 5.2. installing the belt clip 5.3. microheadset installation of external 5.4. – battery installation 6.battery charg...
Page 4
12.1.set menu description 12.2.shortcut menu operation 12.3. “sql” (squelch) 12.4.function “vox” (voice operated transmission) 12.5.‐ select wideband or narrow band “w/n” 12.6.‐tdr (dual watch/dual reception) 12.7. tot(transmission timer) 12.8.ctcss/dcs 12.9. ani 12.10. dtmfst (dtmf tone of ...
Page 5
15.3. receiver 16.troubleshooting 17.warranty.
Page 6
1.safety information: the following safety precautions shall always be observed during operation, service and repair of this equipment. ◇ this equipment shall be serviced by qualified technicians only. ◇ do not modify the radio for any reason. ◇ use only baofeng supplied or approved batteries and c...
Page 7
2.features and functions: -dual-band handheld transceiver with display function menu on the display "lcd". - commercial fm radio receiver (65 mhz ~ 108 mhz). -frequency mode/channel mode - dtmf encoded. - incorporates 105 codes "dcs" and 50 privacy codes "ctcss" programmable. -ctcss & dcs scanning ...
Page 8
3.unpacking and checking equipments: carefully unpack the transceiver. We recommend that you identify the items listed in the following before discarding the packing material. If any items are missing or have been damaged during shipment, please contact your dealers immediately. Battery pack antenn...
Page 9
5. installation of accessories: 5.1. installing the antenna: install the antenna as shown in the figure below and turn it clockwise until it stops. Note: ‐ when installing the antenna, don’t rotate it by its top, holding it by its base and turn. ‐ if you use an external antenna, make sure the ‘swr...
Page 10
Body. -align the battery with the guide rails on the aluminum chassis and slide it upwards until a ‘click’ is heard. -the battery latch at the bottom locks the battery. -turn off the radio before removing the battery. -slide the battery latch, at the bottom of the radio’s body, in the direction indi...
Page 11
3. Plug the dc connector of the adapter into the dc socket on the back of the charger. 4. Place the radio with the battery attached, or the battery alone, in the charger. 5. Make sure the battery is in good contact with the charging terminals. The charging process initiates when the red led lights. ...
Page 12
Over-discharge. 2. Recharge a battery after several months’ storage (li-ion batteries: 6 months), to avoid battery capacity reduction due to over-discharge. 3. Store your battery in a cool and dry place under room temperature, to reduce self-discharge. 8.parts, controls and keys: 8.1.radio overvie...
Page 13
-press the 【f】button, to activate the fm radio on; press it again to deactivate the fm radio. -press and hold on the 【f】button, to activate the alarm function; press and hold it again, to deactivate the alarm function. skside key2/【m】: -press the 【m】button, to turn on the flashlight; press it aga...
Page 14
Icon description ct ‘ctcss’ activated. Dcs ‘dcs’ activated. + frequency shift + - frequency shift - + - frequency offset direction for accessing repeaters. S dual watch/dual reception functions activated . Vox function ‘vox’ enabled. R reverse function activated. N wide band selected. Battery level ...
Page 15
12 advanced operation : you can program your transceiver operating in the setup menu to suit your needs or preferences. 12.1.set menu description: menu function/description available settings 0 sql (squelch level) 0‐9 1 step(frequency step) 6.25/12.5/khz 2 txp(transmit power) high/low 3 save( batt...
Page 16
38 ponmgs(boot display) full/mgs 39 roger(tone end of transmission) on/off 40 a/b‐bp(tone end of reception) off/a/b 41 reset (restore to default setting) vfo/all 12.2.shortcut menu operation: 1.‐press the key menu,then press the key or to select the desired ▲ ▼ menu. 2.‐press the key menu again, co...
Page 17
12.6.‐ tdr (dual watch/dual reception): this feature allows you to operate between frequency a and frequency b. Periodically, the transceiver checks whether a signal is received on another frequency that we have scheduled. If you receive a signal, the unit will remain in the frequency until the rece...
Page 18
Transmitted. ‐“dt‐ani”—under transmitting mode, you can hear the dtmf tone, while you press the key to transmit the code or the code automatically transmitted. 12.11. screv(scan resume method): this transceiver allows you to scan memory channels, all the bands or part of the bands. When the transc...
Page 19
To [-], so the transceiver will always 145,600 mhz in frequency and when you press [ptt] to transmit transceiver, the frequency will automatically move to 145,000 mhz note: under vfo mode, you can do like this. If you need the tx and rx frequency different under channel mode, you can directly store ...
Page 20
Press the ptt of another radio, then you will see the ctcss scanning automatically. When the scanning stops, that means you find the same ctcss as that of another radio, now press 【 menu】to store the ctcss. 12.19. repeater tail tone we all know that repeaters receive on one frequency and simultaneo...
Page 21
19 d116n 40 d244n 61 d356n 82 d516n 103 d734n 20 d122n 41 d245n 62 d364n 83 d523n 104 d743n 21 d125n 42 d246n 63 d365n 84 d526n 105 d754n 15.technical specification: 15.1.general: frequency range: 65mhz‐108mhz(only commercial fm radio reception). Vhf:136mhz‐174mhz (rx/tx). Uhf:400mhz‐480mhz (rx/tx...
Page 22
16.troubleshooting: problem possible cause / solution the radio does not start. The battery is low, replace the battery with a charged battery or proceed to the battery. The battery is not installed correctly, remove the battery and reattach it. The battery runs down quickly. The battery life has c...
Page 23: Warranty Certificate
17.warranty: (better buy the radios from local dealer). Warranty certificate brand: model no.: serial no.: name of purchaser: address: city: zip code: province/state: tel no.: date of purchase: warning: warranty is valid provided it is complete and properly filled in legibly and clearly present the...
Page 24
Safety training information your baofeng radio generates rf electromagnetic en-ergy during transmit mode. This radio is designed for and classified as “occupational use only”, meaning it must be used only during the course of employment by individuals aware of the hazards, warning and the ways to mi...
Page 25
This radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio. • do not transmit for more than 50% of total radio use time (“50% duty cycle”). Transmitting more than 50% of the time can cause fcc rf exposure compliance requirements to be exceeded. T...