Baofeng UV-82 Operating Manual - page 15
12
ADVANCED OPERATION
:
You can program your transceiver operating in the setup menu to suit your needs or preferences.
12.1.SET MENU DESCRIPTION:
Menu
Function/Description
Available settings
0
SQL (Squelch level)
0‐9
1
STEP(Frequency step)
6.25/12.5/kHz
2
TXP(Transmit power)
HIGH/LOW
3
SAVE( Battery save,1:1/1:2/1:3/1:4)
OFF/1/2/3/4
4
VOX(Voice operated transmission)
OFF/0‐10
5
W/N( Wideband/narrowband)
WIDE/NARR
6
ABR(Display illumination)
OFF/1/2/3/4/5s
7
TDR(Dual watch/dual reception)
OFF/ON
8
BEEP(Keypad beep)
OFF/ON
9
TOT(
Transmission timer)
15/30/45/60.../585/600seconds
10
R‐DCS(Reception digital coded squelch)
OFF/D023N...D754I
11
R‐CTS(Reception Continuous Tone Coded Squelch)
67.0Hz...254.1Hz
12
T‐DCS(Transmission digital coded squelch)
OFF/D023N...D754I
13
T‐CTS(Transmission Continuous Tone Coded Squelch)
67.0Hz...254.1Hz
14
VOICE(Voice prompt)
OFF/ON
15
ANI(Automatic number identification of the radio,only can be set by
PC software.
16
DTMFST(The DTMF tone of transmitting code.)
OFF/DT‐ST/ANI‐ST/DT+ANI
17
S‐CODE(Signal code, only could be set by PC software.)
1,…,15 groups
18
SC‐REV(Scan resume method)
TO/CO/SE
19
PTT‐ID(press or release the PTT button to transmit the signal code)
OFF/BOT/EOT/BOTH
20
PTT‐LT(delay the signal code sending)
0,…,30ms
21
MDF‐A(under channel mode, A channel displays. Note:name display
only can be set by PC software.
FREQ/CH/NAME
22
MDF‐B(under channel mode, B channel displays. Note:name display
only can be set by PC software.
FREQ/CH/NAME
23
BCL(busy channel lockout)
OFF/ON
24
AUTOLK(keypad locked automatically)
OFF/ON
25
SFT‐D(direction of frequency shift)
OFF/+/‐
26
OFFSET(frequency shift)
00.000…69.990
27
MEMCH(stored in memory channels)
000,…127
28
DELCH(delete the memory channels)
000,…127
29
WT‐LED(illumination display color of standby)
OFF/BLUE/ORANGE/PURPLE
30
RX‐LED(illumination display color of reception)
OFF/BLUE/ORANGE/PURPLE
31
TX‐LED(illumination display color of transmitting)
OFF/BLUE/ORANGE/PURPLE
32
AL‐MOD(alarm mode)
SITE/TONE/CODE
33
BAND(band selection)
VHF/UHF
34
TX‐AB(transmitting selection while in dual watch/ reception)
OFF/A/B
35
STE(Tail Tone Elimination)
OFF/ON
36
RP_STE(Tail tone elimination in communication through repeater)
OFF/1,2,3…10
37
RPT_RL(Delay the tail tone of repeater)
OFF/1,2,3…10