Baofeng UV-82 Operating Manual - page 16
38
PONMGS(Boot display)
FULL/MGS
39
ROGER(tone end of transmission)
ON/OFF
40
A/B‐BP(Tone end of reception)
OFF/A/B
41
RESET (Restore to default setting)
VFO/ALL
12.2.SHORTCUT MENU OPERATION:
1.‐Press the key MENU,then press the key or to select the desired
▲
▼
menu.
2.‐Press the key MENU again, come to the parameter setting.
3.‐Press the key ▲ or ▼ to select the desired parameter.
4.‐Press the key MENU to confirm and save, press the key EXIT to cancel setting or clear the input.
‐Note:
Under channel mode, the following menu settings are invalid: CTCSS,DCS,W/N,PTT‐ID,BCL,SCAN ADD
TO,S‐CODE,CHANNEL NAME. Only the H/L power could be changed by pressing ‘#’ .
12.3.
“SQL” (SQUELCH)
‐The squelch mute the speaker of the transceiver in the absence of reception.
With the squelch level
correctly set, you will hear sound only while actually receiving signals and significantly reduces battery
current consumption.
It is recommended that you set Level 5.
12.4. FUNCTION “VOX” (VOICE OPERATED TRANSMISSION):
‐This function is not necessary to push the [PTT] on the transceiver for a transmission. Transmission is
activated automatically by detecting the radio voice. When finish speaking, the transmission automatically
terminated and the transceiver will automatically receive signal. Be sure to adjust the VOX Gain level to an
appropriate sensitivity to allow smooth transmission.
12.5.‐ SELECT WIDEBAND OR NARROW BAND “W/N”: (12.5kHz/6.25kHz)
In areas where the RF signals are saturated, you must use the narrow band of transmission to avoid
interference in adjacent channels.