Bar Aid Baraid 400-10A Installation And Operation Instructions Manual - Baraid
IO-0000000125-002-EN / 14. Nov. 2013
28
BaraiD
Installation and Operation Instructions
EN
Problems and malfunctions
Nature of the problem Possible cause
remedy
Streaks and stains on
washware.
Rinse aid concentration too high (stripe or
bubble formation).
Reduce concentration (see operating
instructions).
Hard water or high mineral content.
Check water quality.
Every local water works holds data on the
composition of the water they supply and
will provide these on request.
Reference values: Ideal hard water value:
0 - 3 °d (total hardness). Ideal mineral con-
tent value: for glasses, max. conductivity
100 µS/cm, for dishes, still viable to max.
400 µS/cm.
Rack is not suitable for type of dishes
(sloping).
Use appropriate racks to create a sloping
position which allows water to drain away
from cavities.
Inadequate rinse aid dosing causes stains. Increase rinse aid dosing (see operating
instructions).
Machines with integrated softener: use of
wrong salt (e.g. tablets).
Do not use salt tablets.
9.1.2 Other problems
Nature of the problem Potential causes
remedy
Glasses are totally or
partially cloudy.
Surface of glasses is rough and porous,
this is called glass corrosion.
Use new glasses, this is not caused by a
malfunction on the machine.
Glass/dish breakage.
Use of unsuitable dish or glass racks.
Use suitable racks.
9.2 Malfunctions
Nature of the problem Potential causes
remedy
Machine switches off
suddenly during opera-
tion.
Machine coupled to a maximum system or
locked against other current consumers.
Have machine connected separately (elec-
trician!).
A site fuse has tripped.
Check site fuses.
Temperature sensor/pressure transmitter,
boiler or tank defective.
Contact your Service Partner.
All4keyLEDsflash.
Controller faulty
Contact your Service Partner.