Barco PH series Safety Manual - page 16
3. Lamp replacement
(e)
(d)
Image 3-9
Note:
You cannot turn on the projector without attaching the lamp cover.
12.Insert the side cover (c) into the projector and tighten two screws (a) on the rear and two screws (b) on the side of the side cover
using a Phillips screwdriver.
(c)
(b)
(a)
Image 3-10
3.4
Reset of the lamp operation time
What can be done?
You can reset the lamp operation time of the newly installed lamp using the menu.
How to reset
1. Plug the power cord into the wall outlet.
2. Press the POWER key.
3. Display the FEATURE menu in the ADVANCED menu.
4. Select ADVANCED MENU by pressing the ▲ or ▼ key.
ADVANCED MENU
ENTER
Image 3-11
5. Press the ENTER key.
6. Select LAMP 1 TIME RESET or LAMP 2 TIME RESET by pressing the ▲ or ▼ key.
LAMP 1 TIME RESET
OK
LAMP 2 TIME RESET
OK
Image 3-12
7. Press the ENTER key.
The confirmation dialog appears.
EXECUTE LAMP 1 TIME RESET ?
OK : ENTER CANCEL : MENU
Image 3-13
8. Reset by pressing the ENTER key.
When the lamp operating time is not reset, press the MENU key.
14
R5905598 PHXX SERIES 28/01/2014