BARO BR-300A User Manual - page 9
PHYSICAL LAYOUT: REAR
9
www.barosnt.com
Power Parts
1.
Power Cord Port
Connect the power cable supplied
with the amplifier to this port.
Remember that the amplifier is
designed to operate on 220V/60Hz
inputs. Only use the power cable
supplied with your product.
2.
Fuse Holder
The amplifier fuse is located under
the power cable port. If replacement
is required, be sure to source the
correct fuse from your Baro
representative.
3.
Ground Terminal
Should be used to properly ground
the product to avoid possible risks of
electrical shock. The terminal can
also be used to alleviate any hissing
or buzzing sounds. These are
typically caused by electrical
interference somewhere in the system.
4.
Fan
Fan used for cooling the amplifier.
Ensure it is free of any blockages and
not placed too closely against walls
or other surfaces. The fan speed may
fluctuate with the internal temperature
of the product.
7.
Record Output Jack
Use this output for connecting and
recording to DAT, CD, and cassette
devices, as it ensure the proper
output for optimal recording.
8.
Mic Output
Output designed for microphone
devices specifically.
Amp Outputs
9.
Speaker Outputs
Speaker outputs for main right and
left speakers. The default
configuration is for each channel to
output a maximum of 4 ohms, as
according to common speaker cable.
In the case an auxiliary speaker is
required, the speakers may be
connected to SURROUND LEFT and
RIGHT using the correct polarity to
provide three-dimensional sound.
(Before connecting speakers, confirm
Left/Right Polarity and Impedence)
1
2
3
9
8
5
6
7
4
Inputs/Outputs
5.
Auxiliary Inputs
Use these inputs to connect audio
devices such as cd players, mp3
players, or radios. 1 and 2 may be
connected to the front and chosen by
the selector.
6.
Line Output
Used as output to other devices,
amplifiers, sub woofers, and sound
systems.