Basler ip fixed dome camera pole mount kit installation guide document number: aw000993 version: 01 language: 000 (english) release date: 8 april 2011.
Contacting basler support worldwide europe and the middle east: basler ag phone: +49-4102-463-303 an der strusbek 60 - 62 fax: +49-4102-463-599 22926 ahrensburg email: bc.Support.Ip.Emea@baslerweb.Com germany the americas: basler, inc. Phone: +1-610-280-0171 855 springdale drive, suite 203 fax: +1-6...
Pole mount kit installation guide basler ip fixed dome camera 1 1 introduction document intent the intent of this document is to help you install a pole mount kit for the basler ip fixed dome camera. This document should be used in combination with the basler ip fixed dome camera installation guide....
Pole mount kit installation guide 2 basler ip fixed dome camera 2 installation 1. Assemble the adapter plate, adapter plate gasket, bracket plate, and pole bracket as shown below using four m5 x 25 screws and four m5 nuts. Screw the hole plug into the top hole in the adapter bracket. Make sure that ...
Pole mount kit installation guide basler ip fixed dome camera 3 2. Use two worm gear band clamps to attach the bracket assembly to the pole as shown in the top and side views below. Note that the screw on the worm gear mechanism snaps open to allow you to slip the band through the gear mechanism wit...
Pole mount kit installation guide 4 basler ip fixed dome camera 3. Obtain the cap nut from the installation kit. Route the network and secondary cables through the cap nut and through the bottom hole in the adapter plate as shown below. Do not screw the cap nut onto the threaded nipple at this point...
Pole mount kit installation guide basler ip fixed dome camera 5 4. Refer to the exploded drawing below, and place the bracket arm gasket on the back of the bracket arm. Route the cables through the bracket arm and then attach the bracket arm to the adapter plate using three m5 x 20 screws. 5. Apply ...
Pole mount kit installation guide 6 basler ip fixed dome camera 8. Obtain the split grommet from the installation kit. Place the two cables in the grooves in the split grommet as shown to the right. Note: if you are using only one cable, use the split grommet with only one groove. 9. In order for th...
Pole mount kit installation guide basler ip fixed dome camera 7 10. Insert the grommet into the threaded nipple. You will need to push on the grommet firmly to seat the grommet in the nipple. 11. Slide the cap nut up to the end of the threaded nipple and screw the cap nut onto the nipple. 12. Follow...
Pole mount kit installation guide 8 basler ip fixed dome camera.
