Bat-caddy X3 Pro User Manual - page 15
14
Please note: distance measurements will only be correct if you travel in a straight line to your
ball.
The ON/OFF button; this button controls the trolley’s power. Press and hold it for 2-5
seconds for the caddy to turn ON/OFF. The LCD Display will light up and show the battery
charge level, speed indicator, and short and total distance measurement. Release once turned
The Preset Distance button; press this button once, and it will be preset to 20 meters
(22 yards); however, you can adjust the distance you wish your cart to travel by turning the
speed knob either clockwise (increase distance) or counterclockwise (decrease distance), and
then press the button again to start motion. The caddy will travel the distance you preset and
stop by itself. You can adjust the caddy’s speed seamlessly by turning the speed knob while it
is already in motion. When the caddy is in motion, you will see “A-B” flashing on the screen
display. If you wish to cancel this function while the caddy is in motion, simply press the
button again.
The Motion Indicator; this indicates that the caddy is in motion. This image will flash
on the display while the caddy is in motion, and it will disappear when the caddy comes to a
stop.
The Warning Indicator; this indicates that there is a problem with the power supply.
When this appears on the display, please check the battery cable and connections.
The Battery Charge Indicator; this bar display indicates your remaining battery charge.
The highest amount of remaining battery charge is indicated by all the bars’ being displayed
on your screen display; as the battery charge decreases, the number of bars will decrease.
When only one or two bars remain, the battery needs to be recharged immediately.
The Speed Level Indicator; this indicates the speed at which your caddy is travelling. If
you wish to adjust the speed, simply turn the speed knob.
The GO/STOP or Cruise Control button; when your caddy is in motion, press this
button to stop the caddy and press it again to resume your caddy’s motion. The caddy will
resume its motion at the last speed you set up.
General Instructions
-
In order to turn the caddy on push the On/Off switch The LEDs should light up.
-
While holding on to the handle, start dialing the speed control with your index
finger slowly forward, or clockwise. The caddy will start moving forward. Adjust
the speed seamlessly to the desired pace. Reduce speed by dialing backwards.
-
To stop or slow the caddy down, either dial the speed control knob backwards or
use the cruise control or On/Off button as described previously.