BiPOM Electronics UVC Quick Start Manual - page 4
Manual is about: GadgetPC Single Board Computer
of
14
Page 4
2. Configure UVC camera with Linux Control Panel
In order to configure UVC camera, start Linux Control Panel software from Start -> All
Programs -> GadgetPC -> Linux Control Panel. After Linux Control Panel starts, open
vars.sh file that is located in c:\bipom\devtools\GadgetPC\sh ( if you installed Linux
Control Panel to default path ).
Select File
à Open from the menu and open vars.sh file in sh folder. By default, the
program will start from the folder where GadgetPC release was installed.
When you open vars.sh file, you will see configuration group icons such as Hardware &
Peripherals, Software, System and Network.