BuildXell BC 2200 User Manual - page 10
10
Adjust the position of the fixation on the tube of the machine,in order to obtain a good
balance between the engine and the cutting system.
Mounting nylon head
Insert a screwdriver into the slot lock (2 holes positioned on steel protection sleeve and shaft
drive), unscrew the nut in a clockwise direction using the supplied wrench, and remove the metal
cover, leaving only flat washer.
Screw the nylon cutting head.
Check complete blocking of nylon head, then remove the screwdriver from locking seat.
Mounting three teeth blade
Insert a screwdriver into the slot lock (2 holes positioned on steel protection
sleeve and shaft drive), unscrew the nut in a clockwise direction using the
supplied wrench, and remove the metal cover and flat washer.
Position knife cutting into its place in transmission shaft, put flat washer and
metalic cover.Fasten the nut counter clockwise direction then remove the
screwdriver.
Make sure that all different parts of the cutting tool are securely fastened as
above .
Mounting harvester head
1. Base
2. Protector plate
3. Screw M5X10
4. Gear box
5. Base plate assy.
6. Flat pad 5x12x1.5
7. Screw M5x 14
8. Up clamp
9. 80T Blade
10. Down clamp
11. Scraper seal
12. Nut M10x1.25
13. Collection box
14. Screw M4x8
Operation
WARNING! Never use steel wires or other materials for cutting.
Fuel mixture
Use a fuel mixture of 4% ( 4% sintetic oil + 96% gasoline Euro 95)
You must use
the mixture during the three weeks that follows its preparation.
Shake accurately the mixture in the fuel tank before any use,in order to re-mix the oil with
the gasoline.
This operation should be done in an open area away from any flames or sparks ,while the engine
is turn off. Do not smoke and do not use the telephone during operation.
Engine start
1.Push the start button on the
right handle in position “I”
2.Pull and block the gas lever on the right handle.