BuildXell BC 2200 User Manual - page 11
11
3.
Press on the >,under the carburetor,4 or 5 times ,to allow the gasoline to arrive on
the return fuel tank transparent gasoline pipe.
4. Push the starter lever of the carburetor in position
”ON”
5. With your left hand,grip the brush cutter and press the transmission shaft in order to keep firmly
positioned the machine on the ground ,and with the right hand pull slowly the handle recoil starter
until the pawls hook onto the flywheel.
6. Pull hardly 4 or 5 times the handle recoil starter until the starting. Never pull the recoil starter to
its all length in order to avoid damages to the recoil starter
7.Release the starter level ½ halfway back for approx 10-20 sec and after that fully release to
ÖFF” position.
8.Pull the gas lever to unblock and start to use the machine.
If the engine do not start,may be the spark plug is wet,in this event ,unscrew the spark plug ,wipe
and dry it and pull the recoil starter several times ,without the spark plug in place ,in order to clean
and ventilated the combustion chamber.
Grinding
During the first ten hours of work ,run the engine at a moderate rpm,we advise you ,in any
case ,do not use your engine at high-speed as the different components must adjust one with the
others during grinding.At the end of the grinding the engine will reach its maximum power .
After the two first hours of work,make a pause and check that all nuts and screws are securely
fastened ,tighten if necessary.
Carburetor adjustment
During a normal use,the carburetor may have some slight changes ,especially ,when there are
some changes of working conditions and after many hours of work or because of variation of
temperatures or pressures in the surrounding.
If the carburetor needs adjustment proceed as follows:
Screw clockwise the yellow screw of the carburetor until it comes to the base,never force it .
From this position unscrew it by one and a half turn.
Start the engine and accelerate at the maximum.
Find the point where the engine is at the maximum rpm by screwing or unscrewing at around
1/8 of turn at each time.
When you have founded the maximum rpm,unscrew of one 1/4 of turn the screw,in order to
increase the mixture gasoline.
Idle speed adjustment
For a correct adjustment,this operation must be done while the engine is hot .
Screw or unscrew the butterfly screw until the engine is at around 2500 rpm.
Those adjustments require a special tool control .If you do not have it ,contact an approved
after sale service.
Grass Cutting
Cut the grass ,like if you were in a corridor of 1.5 meters ,wide ,move step by step balancing the
machine right and left,and vice-versa.Make sure at each step that you are still well balance on
your feet .If you are using the 3 teeth blade for the grass ,always cut your right to left and leave a
pile of cut grass on the left for later gathering.
If possible, avoid stones even small ones,piles of earth,small piece of wood or anything that could
be hidden or poorly visible in the grass.If you hit a large object by accident,or if you block the
cutting tool due to overloading ,or overload of grass or stringy vegetal material wrapped in the
cutting tool,you must : reduce the speed to the idle speed and disengage the clutch .Make sure
that the cutting tool is stopped by pushing tile stop button .
Put the brush cutter on the ground and check that the cutting tool has not been damaged such as
breakage of teeth for the blade,cracking.If necessary ,change the cutting tool,If the tool is only
wrapped by vegetal material,with your pair of gloves remove the vegetal materials and clean the
cutting tool.