Bukh DV10 Workshop Manual - page 262

R18 

009W2229-R01 

Fit thrust washer, the oil pockets of which should 

turn towards the wheel for “AHEAD”. 

Fit the disc springs which should touch with the 

outside diameter. 

Check the tightening of the disc springs. 

The inside diameter of the disc springs must, 

when slack, in proportion to the front be 

min. 1.1 mm (measure A). 

Tighten the disc springs with bush 1 x 56 136 994. 

Measure disc clearance between inner disc and 

washer with a feeler gauge in two places which 

are opposite one another. 

The disc clearance to be 0.75 – 0.85 mm. 

Deviations should be adjusted with washer 

available in different thicknesses. 

“Note”: Tighten the disc springs on the side for 

“ASTERN” with bush No. 1 x 56 136 995.