Bukh DV10 Workshop Manual - page 277

R33 

009W2229-R01

Picture 55 

Fit the screws M8x25 with washers in the 

gearbox. Put the gear shift lever in 

“neutral” (the sliding sleeve is also in 

“neutral” position). 

Place the gearbox with gasket in the 

opening of the housing and press the 

shifting eccentric down into the shifting 

fork. In connection with this check at the 

same time with a light pressure of the 

eccentric pointing to the assembly the 

axial clearance between the sliding sleeve 

and the shifting fork. 

Secure the shifter housing in this position. 

“NOTE”: When checking the axial 

clearance it must be checked 

whether the fixing screws hit 

against the walls of the gearbox 

because of the slots which may 

lead to wrong adjustments. 

Adjustment can be carried out by axial 

displacement (angle 90° must be 

maintained, see picture 40). 

Picture 56 

Tighten the shifter housing with a torque 

of 17 Nm (1.7 Kpm). 

Shift the shift control lever in both 

directions and check the function of the 

reversing. 

The sliding sleeve should be connected 

(click) in both directions when the angles 

of engagement are as equal as possible. 

Besides, it must always be possible to 

turn the shift control lever 37° in either 

direction without much resistance. 

Picture 57 

At last fit the dip stick and the locking ring 

at the end of the input shaft when fitted. 

Fill oil in the gearbox to a quantity 

corresponding to the upper mark on the 

dip stick.