Bukh DV36/48 Workshop Manual - page 157
of
196
R17
009W2329-R01
Fit needle bearing housing, wheel for “AHEAD”
and washer.
Check the axial clearance of wheel for “AHEAD”.
It should be 0.1 – 0.4 mm.
“Note”: For “ASTERN” the axial clearance can be
adjusted by fitting an intermediate washer (thrust
washer).
First fit a washer. Then fit an inner disc and the an
outer disc.
Fit 4 inner and 3 outer discs in this order.
Fit wheel for “AHEAD” with clutch discs on the
thrust collar.
First fir the driving pins through the thrust collar
and the fit the thrust collar with clutch discs and
wheel for “AHEAD” over the needle case on the
input shaft in the sliding sleeve.