Bukh DV36/48 Workshop Manual - page 46
of
196
009W2329-R01
D4
Replacement of gear rim
1. Remove the flywheel.
2. Saw with a hacksaw as far int
o the gear rim as possible without damaging the
flywheel.
3. Split the gear rim in the sawed slot with a chisel.
4. Clean the recess on the flywheel.
5. Heat the new gear rim gradually to about 225°C (dark blue) and fit it. Make sure at the
fitting that the gear rim lies true against th e recess and that the chamfered edge turns
towards the starter engine.
Drwg. 008E7312