Bukh DV36/48 Workshop Manual - page 158
of
196
R18
009W2229
Fit thrust washer, the oil pockets of which should
turn towards the wheel for “AHEAD”.
Fit the disc springs which should touch with the
outside diameter.
Check the tightening of the disc springs.
The inside diameter of the disc springs must,
when slack, in proportion to the front be
min. 1.1 mm (measure A).
Tighten the disc springs with bush 1 x 56 136 994.
Measure disc clearance between inner disc and
washer with a feeler gauge in two places which
are opposite one another.
The disc clearance to be 0.75 – 0.85 mm.
Deviations should be adjusted with washer
available in different thicknesses.
“Note”: Tighten the disc springs on the side for
“ASTERN” with bush No. 1 x 56 136 995.