1. DL manuals
  2. Bulldog Security
  3. Car Alarm
  4. 3001
  5. Installation And Owner's Manual

Bulldog Security 3001 Installation And Owner's Manual

Summary of 3001

  • Page 1

    System features ....................................... 1 technical assistance .................................. 1 wiring instructions ................................... 2 installation instructions ............................. 3 operating instructions .............................. 4-5 contents t...

  • Page 2

    System features two four button remotely activates alarm in chirp or voice mode. Activates car finder and remote controls instant panic. High quality siren speaker extremely loud siren and voice deters thief from further tampering. Battery back-up (optional) alarm will continue to sound even with ve...

  • Page 3

    Wiring instructions 2 1. Green wire (ground trip) when grounded with the optional modules the alarm will say “you are too close to the vehicle, please move away”, if the alarm is armed with armed talk button. 2. Grey wire (ground trip) when grounded the alarm will say “i was tampered with”, and the ...

  • Page 4

    3 installation instructions fuse + blue - negative output red yellow - antenna grey - negative trip alarm green - negative trip voice orange loop optional ground base to battery led light.

  • Page 5

    Note: before operating your alarm, slide the protector down (attached to the back of your remote transmitter) snap off the back and snap to the front. Arming press transmitter button #1 (arm talk). The alarm will set and a man's voice will acknowledge by saying "system armed”. Note: your alarm will ...

  • Page 6

    Automatic (passive) arming to activate passive arming. Press and hold down transmitter button #2 (arm chirp) for 10 seconds. Alarm will respond with a tone and then say “system armed”. Your alarm will automatically arm itself in 60 seconds after each time you turn off your engine. After disarming yo...