Bulldog Security 3001 Installation And Owner's Manual - page 3
WIRING INSTRUCTIONS
2
1. Green Wire (Ground Trip)
When grounded with the optional modules the alarm will say “You are too close to the vehicle,
Please move away”, if the alarm is armed with armed talk button.
2. Grey Wire (Ground Trip)
When grounded the alarm will say “I was tampered with”, and the siren will sound. This is usually
triggered by shock sensors, glass breaking, negative door or hood pins.
3. Yellow Wire (Antenna)
Antenna wire should never be cut or lengthened. Keep as far away from metal and as straight as
possible.
4. Red Wire (+12V)
Primary power, connect to any constant positive terminal. Note: You must press at least one button
on each transmitter within 35 seconds after this connection or the alarm will not work. This step
must be repeated after the power is disconnected for any reason. When reconnecting the red power
wire from the alarm to the (+) positive side of the battery, make sure that if you had already
installed a 9 volt battery in the back of the alarm, remove the 9 volt battery first, then connect
the alarm to the car battery, next, make sure the unit operates properly, then place a fresh 9
volt battery in the back of the unit. Note: If you have disconnected battery power, or you have
used your vehicle to jump start another vehicle, you must perform the above steps to be sure the
unit is working on 12 volt power not the 9 volt battery.
5. Blue Wire (Neg. Output)
Connect to (optional) L.K.L. Module or other module that requires grounding input. The output
goes to ground when armed, open when disarmed. Never connect this wire directly to the vehicle!!
6. Orange Loop (Current Sensing)
Your alarm will ignore all current changes for 45 seconds after the alarm is set.
Note: Professional installers should run a ground wire from the battery to the base of the alarm.
The Superbright LED is ON when the system is ARMED and OFF when the system is DISARMED.
WARNING!
This security system is highly complex in its installation and adjustment procedures.
IT IS STRONGLY RECOMMENDED THAT THIS INSTALLATION MANUAL IS READ
PRIOR TO INSTALLATION. This security system is not a “Do-it-yourself” product.
Instructions are NOT provided or enclosed. Installation performed by non-Bulldog
dealers or consumers will NOT be supported by Bulldog Security.