Bulldog Security 3001 Installation And Owner's Manual - page 6
Automatic (Passive) Arming
To activate passive arming. Press and hold down transmitter button #2 (arm chirp) for 10 seconds.
Alarm will respond with a tone and then say “system armed”. Your alarm will automatically arm itself
in 60 seconds after each time you turn off your engine. After disarming your system, you have
approximately 60 seconds to start your motor before the alarm will rearm itself. To deactivate passive
arming, press and hold down transmitter button #2 (arm chirp) for 10 seconds. The alarm will respond
with one tone and say “system disarmed”
High Theft Area
To make your alarm say “system armed” every 30 seconds. Press transmitter button #3 (finder) immediately
after arming your alarm with button #1 (arm voice). To make your alarm chirp twice every 20 seconds,
simply press transmitter button #3 (finder) immediately after arming your alarm with transmitter
button #2 (arm chirp). Either option will be for this arming only. The system will return to normal
operation after it is disarmed. NOTE: If the vehicle is violated, a man's voice shouts "I was tampered
with" and the siren sounds. After 30 seconds; if the violation stops, the alarm will stop and rearm
itself.
If your vehicle is violated
A man’s voice shouts “ I was tampered with”, and the siren sounds. 35 seconds after the violation
stops the alarm will stop and rearm itself.
Adding a New Transmitter
With the system armed, press and hold button #1. The system will respond “System Disarmed.” Continue
to hold until the unit responds “Thank You” (approximately 10 seconds). At this time, release button
#1 and press any button on the transmitter you want to add. The alarm will respond “System Disarmed”.
Both transmitters will now operate the system.
5