Bulldog Security DELUXE 500 Owner's Manual - Operation
. .
14
OPERATION
A. TO REMOTE START THE VEHICLE:
When you want to Remote Start your vehicle,
1
. Press the
button
twice on the transmitter
2
. The parking light will flash to indicate the remote starter
received the signal. (A melody sounding from your Remote
LCD transceiver and the icon will flash on the LCD screen
to confirm the remote starter was activated.)
3
. The engine will start in approximately 5 seconds.
4
. Once the engine is running, after couple seconds the parking
light will turn
on
and climate controls will activate and adjust
the vehicles interior temperature to your preset setting.
(While the vehicle is running, the icon and the minutes
digit on the LCD screen will flash and it will indicate a count
down timer based on the 5, 10, 20 or 30 minute run time
you have selected)
5
. The vehicle will run for 5 to 30 minutes and automatically
shut down. (When the unit shuts off the count down timer
will turn off and the transmitter will play a melody.)
NOTE:
The Remote Start Unit will not start the vehicle if any
one of the followingconditions exists:
1
. The hood is opened.
2
. The brake pedal is pressed.
3
. Move the optional remote start enable toggle switch to
OFF
position.
(If installed)
4
. The gear selector is in any gear other then PARK or NEUTRAL
5
. The e-brake is not set.
(for Standard Transmission Vehicle)
SAFE START (Child safety mode)
(Factory defaults setting) press the
button
twice on the transmitter to
start the vehicle. Programming this feature will eliminate an accidental
remote start, when kids enter this transmitter, it enquires:
The user presses the transmitters and
buttons
at the same time to
remote start the vehicle.