Bullet DVR dvr Operating Manual - page 7
operating
manual
operating manual
Product appearance and specifications are subject to change without notice
Ejecting the CF memory card
:
1. Wait until the Status LED turns to green .
. Disconnect the AC Charger and turn the Power Switch to the OFF position .
. Firmly press the Eject button and grab the CF card adapter by the edges
and pull it out of the unit . If you have problems reaching the card, there are
2 small holes on each side of the adapter, which you can grab with a sharp
object and pull out .
Caution:
Once recording has stopped, it takes a short time to save the buffered data to the
memory card . The Power Switch cannot be turned off, and the AC Charger should NOT
be disconnected until the LED status light turns to steady green . Ejecting the CF card
too early could damage the integrity of the video file and ruin your recording session .
Video file name
:
Recorded video files are stored on the CF memory card with the prefix DVR_ by
default, and can be changed by the user . The maximum number of files on the same
CF card is 1000, starting with DVR_000 .avi and is incremental to DVR_999 .avi
Compatible Compact Flash memory cards
:
Currently, the Bullet DVR unit supports the following brands of CF memory cards:
o Sandisk Ultra & Ultra II
o Sandisk Extreme III & Extreme IV
o Transcend 133x
o A-Data 133x & 266x
o Lexar 80x
There are other brands which might work, but have not yet been tested for
compatibility . The minimum speed rating of the card should be 60x, otherwise your
videos could appear choppy .
Contact your Bullet DVR dealer for more information .
Bullet DVR Status Light
:
o Steady Green = Unit is in Stand-by mode, ready for operation .
o Quick-Flashing Red = Unit is recording normally .
o Slow-Flashing Red = Unit is recording, but no video source is detected .
o Flashing Orange = Compact Flash memory card is full .
o Flashing Orange ( times) = Low battery, recording will stop and unit will enter
sleep mode .
o Steady Orange = Unit is in sleep mode, press & hold the stop button to wake
it up .
Battery Care & Maintenance
:
The Bullet DVR unit contains a Lithium-Ion rechargeable battery, which has a lifespan
of around years . The battery comes already supplied with a partial charge, so that
you may use it immediately after you open the package . To re-charge the battery,
simply plug-in the AC Charger and the charging procedure will begin automatically .
The Charging Light on the side of the unit will remain red during this time, and will
turn off once the battery is full .
Charging a very low battery takes approximately to 8 hours . A freshly charged
battery should power up the Bullet DVR for around 90 minutes, and about 0 minutes
when a Bullet Camera is connected to the unit as well .