Bullet DVR dvr Operating Manual - page 9
9
operating
manual
operating manual
Product appearance and specifications are subject to change without notice
1. Attach the base plate to a flat surface on the
vehicle, using the rivets . Mark the 4 corners of
the bracket and drill the receiving panel . If the
thickness of the panel is greater, you may use
longer rivets than the ones supplied with your
kit . Note the orientation of the bracket with the
word “TOP” located on the hinges side .
. Place the Bullet DVR unit on the base plate,
aligning each of the grooves with the
tabs found on the bracket . Make sure the
logo on the DVR is oriented correctly with
the “TOP” marking, which is the side with the
metal hinges .
. Attach the top plate to the bottom plate, using
the metal hinges .
. Lock the Bullet DVR unit in the bracket, using
the Quick-Release pin . Align the pin holes
and push the pin all the way in, until the
locking ball is visible on the other side .
Configuring the unit
:
When you power up the Bullet DVR, the unit will look for the file device.ini located on
the root directory of the memory card . This file contains all the parameters configured
by the user . When using for the first time, it will load up the default settings from the
factory . If no device.ini file is found, the unit will use the last known configuration .
There are two ways to change the configuration settings of the device.ini file . It can be
done by installing the configuration utility for Windows PC, or directly from the Bullet
DVR unit, using the built-in menus and buttons on the control panel .
Using the Bullet DVR Configuration utility
:
Before you start the program, make sure the Compact Flash memory card is already
inserted into the computer or card reader . Once the card is detected, the utility will be
able to start . You will see a number of icons at the top of the screen . Each of these tabs
will take you into a different section of the software .