BullFrog 2000 Owner's Manual - page 15
Page 15
Bullfrog Spas Owner’s Manual
clean.
2- The amount of water flow may be inadequate. Make
sure the spa is filled correctly.
3- A pressure switch may have malfunctioned. The spa
will continue to operate, but the heater will not
activate. Contact your authorized Bullfrog Spa Dealer.
Open Sensor (Spa is deactivated)
If the Control Pad display shows “Sn” (meaning
sensor), then either the high-limit or water
temperature sensor has malfunctioned. This must be
repaired only by an authorized Bullfrog Portable Spa
Dealer.
Standby Mode (Spa is deactivated.)
When “Sb” appears on the panel display, all spa
functions have been disabled except for freeze
control. Press any button on the control pad to reset
the system. The "Standby Mode" is primarily used to
prevent the pumps from being activated while
changing JetPaks, cleaning the filter or cleaning the
skimmer basket.
Warning! Shock Hazard! No User Serviceable Parts.
Do not attempt service of this control. Contact you
authorized Bullfrog Spa Dealer. Follow all Owner’s
Manual power connection instructions. Installation
must be performed by a licensed electrician, and all
grounding connections must be properly installed.
DELUXE CONTROL SYSTEM
MASTER CONTROL PAD (Fig. L:)
Temperature Adjustment (80°F - 104°F)
The current temperature is constantly displayed on
the LCD. Press either the "Warmer" or "Cooler" button
once to display the set temperature. (The set
temperature is designated by a triangle in the upper
left corner.) Each time either button is pressed again,
the set temperature will increase or decrease
depending upon which button is pressed. After three
seconds, the LCD will automatically display the
current spa temperature.
Jets 1
Press the "Jets 1" button to operate pump 1. Press the
button once to turn on the low-speed pump. Press the
button again to turn on the high-speed pump, and
again to turn off the pump. The low-speed pump will
automatically turn off after 2 hours and the high-
speed pump after 30 minutes. Due to Automatic Spa
Control, the low-speed pump will start automatically
when the heater is turned on, when a filter cycle is
activated, or when a freeze condition is detected. If
the low-speed pump is on under the Automatic Spa
(Figure L) Deluxe Control Pad