BullFrog 2000 Owner's Manual - page 16
Page 16
Bullfrog Spas Owner’s Manual
Control, it can only be deactivated by entering the
Standby Mode.
Jets 2
Press the "Jets 2" button to operate pump 2 (if
installed). Press the button once to turn on the low-
speed pump. Press the button again to turn on the
high-speed pump, and again to turn off the pump.
The low-speed pump & the high-speed pump will
automatically turn off in 30 minutes.
Light
The spa light has 3 settings. Pressing the "Light"
button changes the intensity from the brightest
setting to the dimmest setting, then turns it off. The
spa light will turn itself off after 4 hours of operation.
Standard and Economy Mode
Press the "Mode" button to switch between Economy
and Standard modes. When in Economy mode, the spa
only heats water during filter cycles. In Standard
mode, the spa maintains the desired temperature at
all times.
Standby Mode
(Use when removing JetPaks or cleaning the filter)
Press either the "Warmer" or "Cooler" button and then
the "Light" button. The display will show "Stby" and all
functions will be disabled except for freeze control.
Press any button to reset the system.
Auxiliary Control Pads (See Fig. M)
Pump 1: Press the "Jets 1" button to operate pump 1.
Press the button once to turn on the low-speed pump.
Press the button again to turn on the high-speed
pump, and again to turn off the pump. The low-speed
pump will automatically turn off after 2 hours and the
high-speed pump after 30 minutes.
Pump 2: Press the "Jets 2" button to operate pump 2.
Press the button once to turn on the low-speed pump.
Press the button again to turn on the high-speed
pump, and again to turn off the pump. The low-speed
pump and the high-speed pump will automatically
turn off after 30 minutes.
Preset Filter Cycles: Your spa will automatically filter
itself twice each day. The first filter cycle will begin
one minute after the spa is energized. The second
filter cycle will begin twelve hours after the start of
the first filter cycle. Filtration duration is
programmable at the Master Control Pad. Press the
"Warm" or "Cool" button, then the "Mode" button, and
"FIL4" will be displayed on the panel. FIL4 is the
default filter time and indicates a 4 hour cycle. To
increase or decrease the filter times, press the "Warm"
(Figure M) Auxiliary Control Pad