Bumbleride indie Owner's Manual - page 6
5 |
Bumbleride
1.800.530.3930 info@bumbleride.com
ASSEMBLING FRONT SWIVEL WHEEL
Locate the front wheel. Loosen the black plastic nut so that the silver washer hooks can move freely.
Locate two small holes on either end of the front aluminum fork on the chassis. Slide the wheel onto the fork and
place each washer hook into its respective hole.
Tighten the black plastic nut to secure the hardware in place. Press the silver lever down so that it lays parallel
to the fork.
LOCKING FRONT SWIVEL WHEEL
The front swivel wheel can be locked in
two positions or remain in the swivel
mode. Rotate the wheel to the desired
locked position (either forward facing or
tucked under the seat). Locate the steel
knob and push it to the side so that it
engages the lock. To unlock, simply lift the
knob and slide it right to the unlocked position.
ATTACHING THE CANOPY
Locate the canopy holsters on the chassis. Insert each canopy clip into its respective holster to secure the canopy
in place. If the additional zip-on lower portion of the canopy is attached, you may snap it to the back of the
backrest using the attached press snaps. The canopy use a dual ratcheting system. To extend the canopy, move one
portion forward at a time. Zip off the rear portion of the canopy to allow the canopy to extend fully forward.
Note the viewing window on the canopy. The fabric flap can be rolled and tied down to allow viewing access into
the stroller.
To remove the canopy, locate the press buttons on
each clip and press while pulling out of holster.
Do not machine-wash canopy. Only spot
clean the canopy fabric.
WARNING: Always snap extended canopy onto the
back of the seat fabric when using with an infant
in the reclined position.