Bungard NE-CUT Original Instructions Manual - Ne-Cut-Manual-E
ne-cut-manual-e
Page 4 / 10
Intended Use
NE-CUT is specially designed to cut FR4 PCB boards up to 3.0 mm or aluminium up to 2 mm thickness.
Depending on customer application cutting of steel (depending on the alloy up 0.8 mm) and plastic (up to
5 mm) is also possible same as paper or film material. The board cutter is preset for board thickness up to
3.0 mm. If you need to cut thicker material you need to adjust the upper blade and the clamping unit.
All other applications require our written consent, or happen at your own risk and peril.
Safety Regulations
Generally
Please read the following text carefully and pay particular attention to information on safety and commis -
sioning.
Keep this folder at a safe place. It contains information which is also for later maintenance and cleaning of
importance.
The machines are not designed to be embedded or interconnection with other machines or systems. They
may only be used in specially equipped rooms and be operated by qualified personnel. Keep away chil-
dren and pets!
Transport
Only use suitable lifting and transport equipment such as forklifts or pallet trucks . Secure the machine
against sliding / tilting
Operation site
The site should be level, site- and slip-resistant. Unrestricted access to the rear of the machine is required
for the installation of add-on parts ; later on it enables you to easily remove the cuttings .
Operating
All dangerous parts are covered as far as technically possible and reasonable. The gap between
table and clamping device is only 5 mm, so it is almost impossible to get your hand into the blade
while the clamping device is mounted.
The only source of danger is behind the machine. Never pull the lever while you or anybody else is
working behind the machine. Especially when somebody is trying to remove the cut boards from be-
hind the machine.
Always were cut proof gloves when handling the blades. Secure the loose blades from being touched
or from falling down.
For very small sections, it may happen that they stick under the knife. Caution, risk of injury! Lower the up-
per knife till the cutting gap is closed before putting your hands into the cutting area.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 2292 / 9 28 28-0, Fax: +49 2292 / 9 28 28-29, E-mail: support@bungard.de