Bungard RLM 419P Instructions For Use Manual - page 3
ved before the laminate goes on the
board. This separation foil will wind up
on the take-up rollers.
Pull the laminate off the lower coil for
about 30 cm. Apply a piece of adhesive
tape to the upper and lower end of the
laminate compound and pull these
‘‘handles’’ to separate the thin and soft
intermediate foil from the laminate.
Stick it to the take-up roller by adhesive
tape and put the take-up roller on top of
the laminate coil. Repeat this procedure
for the upper coil, with reference to the
threading diagram. Make sure the take-
up rollers are driven automatically by
the rotationof the laminate coil.
For the following step you will profit
from two pieces of cardboard of ap-
prox. 300 x 300 size and 1 to 2 mm
thickness.
Turn the laminator main supply on.
Turn the heater and drive switch off.
Wrap about10 cm of the laminate from
the lower coil around the edge of one
piece of cardboard. Insert this edge of
the cardboard into the gap between the
two red laminator rollers. Turn the
knob on the right side of the laminator
so that the cardboard with the laminate
will go into the unit. Continue turning
the knob until you feel a resistance.
This is where the cardboard has to go
between the transport rollers that you
can see from the rear of the unit. Adjust
the speed to 2 on the scale, turn on the
drive switch and keep pressure on the
right knob until the cardboard is taken
by the transport rollers. Stop the drive
before the cardboardleaves the lamina-
tion rollers.
Wrap about10 cm of the upper lamina-
te around the edge of the second card-
board and push this forward onto the
end of the first one. Turn on the drive,
feed the second cardboard between the
lamination rollers and leave the trans-
port on until the first cardboard comes
out of the unit and the second one is still
between the lamination rollers. Access
the back side of the laminator. With a
sharp knife cut the laminate between
the two cardboards. Remove the first
cardboard, peel the laminate off and
keep the cardboardfor further use.
Attention: Never use a knife bladeclo-
se to the lamination rollers. Every
smallest cut will destroy the roller.
Check that the upper and lower lamina-
te superimpose exactly. If necessary,
subsequently loosen the left and right
flange of the upper coil and shift them
left or right until both laminate layers
match. If the laminate is plied during
this adjustment just have the first card-
board go through the unit again, so that
the laminate can self-adjust.
Finally, mountthe inlet roller table: Lift
it at its rear, insert the front end (with
the brush) in the middle of the unit until
it goes into the two lateral pins on the
housing, and lower the rear end until
Bungard Elektronik ·Rilke Str. 1 · D-51570 Windeck
Tel 02292 5036 · Fax 6175 · info@bungard.de
RLM 419P
Instructions for Use
Laminators
Page 3