Bungard RLM 419P Instructions For Use Manual - page 4
this snaps onto the pins as well. Adjust
the lateral guide bar of the inlet table so
that the left PCB edge matches the left
edge of the laminate film.
It is assumed that at the end of each job
you leave a piece of cardboard between
the lamination rollers. This serves to
keep the lamination rollers clean from
molten laminate.
4. Operation
See section 2 for a description of the
control elements. Turn the heaters on.
Set the desired temperature and wait
until the unit has heated up.. Set the
pressure and speed and start the trans-
port. Let the cardboard leave the lami-
nation rollers. Insert a PC board throu-
gh the brushes of the inlet table and
push it slightly until it is taken by the
lamination rollers. If you do several
PCBs at a time feed them one after the
other with about 2 cm distance between
them.
From the rear of the unit, cut the PCBs
off one after the other using a sharp
knife blade. Let the boards cool down
before exposure.
The last sheet that you insert should
always be the cardboard, with its end
still between the lamination rollers.
Turn the laminator off and let it cool
down. If you have yellow safelight in
the room you may leave the unit open.
Otherwise you should cover the lami-
nate coils from daylight.
Attention:Never cover a hot laminator!
5. Service and maintenance
The laminator is maintenance free. It
only needs cleaning, especially if there
was laminate touching the lamination
rollers. Use warm soapy water and a
sponge to remove laminate rests from
the roller surface. Never use hard or
sharp tools. They could damage the
heater wires that are inside the silicone
rubber.
There are no user serviceable parts insi-
de the left and right blue coloured side
compartments. On the rear, beneath the
board outlet, there is a white plate. Be-
hind this plate there is the motor drive
circuit with a fuse. If ever the transport
rollers do not work although speed is
set and the RUN switch is on, you
might have to check this fuse. Replace
it only by one of the same rating and
characteristics.
(C) 2000 Bungard Elektronik
Bungard Elektronik ·Rilke Str. 1 · D-51570 Windeck
Tel 02292 5036 · Fax 6175 · info@bungard.de
RLM 419P
Instructions for Use
Laminators
Page 4