Bunker Hill Security 62368 Owner's Manual & Safety Instructions - Assembly
Page 7
For technical questions, please call 1-888-866-5797.
Item 62368
Sa
Fety
Opera
ti
O
n
n
etw
O
rk
Setting
S
assembly
Thread the Antenna into the Antenna Connector on the back of the Receiver.
Before Mounting
When planning Receiver location:
1. Verify that installation surface has no hidden
utility lines before drilling or driving screws.
2. Select a clean, dry location indoors
with a 120V outlet nearby.
3. Take into consideration the length
of the Power Adapter's cord.
CaUtiOn! Route the cord so as
to avoid a tripping hazard.
4. Make sure the location will remain within
the Receiver's Operating Temperature.
tabletop Mounting
Place Receiver on a flat, level surface. Adjust
the Stand until desired position is achieved.
V
V
OK
new
FULL
SCan
MOtiOn
Stand
(on back)
Figure D
wall or Under Cabinet Mounting
Using the Base as a template, mark locations
of mounting holes on mounting surface.
Mounting
Holes
Base
adjustment
knob
adjustment
knob
Figure e
Solid Surface
1. Using a drill bit slightly smaller than the Screws,
drill pilot holes into the marked locations.
2. Position Mounting Bracket so that
mounting holes align with pilot holes.
3. Drive Screws through mounting holes in Base
and into pilot holes until the Mounting Bracket
is securely attached to the mounting surface.
4. Attach Receiver to Mounting Bracket, then
loosen Adjustment Knobs, adjust Receiver as
needed, then tighten Adjustment Knobs.
Hollow Surface
1. Using a drill bit slightly smaller than the
Anchors, drill holes in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Mounting Bracket so that Mounting
Holes align with anchor holes.
4. Drive Screws through mounting holes in Base
and into anchor holes until the Mounting Bracket
is securely attached to the mounting surface.
5. Attach Receiver to Mounting Bracket, then
loosen Adjustment Knobs, adjust Receiver as
needed, then tighten Adjustment Knobs.
Connect power
1. Connect the Power Adapter’s cord
to the back of the Receiver.
2. Plug the Power Adapter into a 120VAC outlet.
3. Turn the Power Switch to the
On position.