Bunker Hill Security 62368 Owner's Manual & Safety Instructions - Assembly
Page 8
For technical questions, please call 1-888-866-5797.
Item 62368
Sa
Fety
Opera
ti
O
n
n
etw
O
rk
Setting
S
Camera Components and Controls
Mounting
Bracket
Microphone
(on bottom)
infrared
Sensor
Lens
Speaker
antenna
power
Cord
pair
Button
antenna
Connector
power
Cord
Back of Camera
Accessories
Mounting
Hardware
9VDC power
adapter
Figure F
assembly
Thread the Antenna into the Antenna Connector on the back of the Camera.
Before Mounting
note: The included Cameras are programmed to automatically connect to Channel 1 and Channel 2.
1. When planning mounting location and angle:
a. Verify that installation surface has no hidden
utility lines before drilling or driving screws.
b. Take into consideration the length of the
Camera and Power Adapter’s cords. Route the
cords so as to avoid a tripping hazard.
c. Do not install where there are thick walls or other
obstructions between the Camera and Receiver.
d. Select a location high enough so that
it is out of reach of children, but still
covers the desired viewing area.
e. Do not install the Camera facing out of a window.
f. Make sure no strong light will shine
directly into Camera Lens.
g. Make sure location will remain within the
Camera's Operating Temperature.
2. Test each Camera's function in its
intended location
before mounting:
a. Connect the Power Adapter’s cord
to the Camera’s Power cord.
Figure g
b. Plug the Power Adapter into a 120VAC outlet.
c. Verify that there is an image on the Receiver.
note: If there is no image, pair the Camera to the
Receiver according to
pairing on page 11.