Bunn AutoPOD Programming Manual

Summary of AutoPOD

  • Page 1

    Programming manual bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 41170.0000b 05/12 ©2010 bunn-o-matic corporation.

  • Page 2

    Page 2 41170 030912 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) airpots, thermal carafes, decanters, gpr servers, iced tea/coffee dispensers, mcp/mca pod brewers thermal servers and thermofresh servers (mechanical and digi...

  • Page 3

    Page 3 411701 061308 contents lockout switch .............................................................................................4 programming switches...............................................................................5 programming ..................................................

  • Page 4

    Page 4 adjustments & programming programming lockout switch programming the brewer the programming of the brewer is divided into two levels. Brewing adjustments are in level 1. Service func- tions are accessed in level 2. The following function screens are in order of appearance. Each screen will ha...

  • Page 5

    Page 5 autopod bre wer main screen program functions autopod b hidden switch press until display reads "brew lockout" press/hold to exit program small brew step backwards through screens l ll l br bre e prevents brewing if the water temperature is less than the "set ready" temperature. To access thi...

  • Page 6

    Page 6 brew type (a/b) (tea/coffee) tea setting provides half the "purge" pressure as coffee at the end of brew cycle. Brew type a tea done coffee brew oz a: 8.0 (-) done (+) brew meter a: 2 - + brew oz. (a/b) (1-16) adjust brew volume. Brew meter (a/b) (1-5) simplifi ed pulse brew adjustment. 1=pre...

  • Page 7

    Page 7 external relay main control board outputs 12vdc to activate external relay. The n.O. Contact then closes to provide line voltage to the heater in hot water tank. External relay on next off index motor dump runs the pod holder back to the pod ejection position. Load moves it out to the door op...

  • Page 8

    Page 8 factory defaults no yes autopod brewer version xx.Xx test switches allows testing of the membrane switches. Test switches ? No yes air pump activates the air pump motor for the brew tank. Air pump on next off water inlet activates the water inlet valve for the brew tank, and fl ow meter count...

  • Page 9

    Page 9 411701 061308.