1. DL manuals
  2. Bunn
  3. Dispenser
  4. MY CAFE MCA
  5. Use And Care Manual

Bunn MY CAFE MCA Use And Care Manual

Manual is about: Tea & Coffee Pod Brewer

Summary of MY CAFE MCA

  • Page 1

    Use and care of your my café ™ automatic tea & coffee pod brewer p2955 model mca commercial type the bunn logo is a registered trademark of bunn-o-matic corporation. My café is a trademark of bunn-o-matic corporation. 37268.0000d 10/05 ©2004 bunn-o-matic corporation model: serial number: record thes...

  • Page 2: Hazardous Voltage!

    2 hazardous voltage! Can cause fire or electrical shock! Do not disassemble the brewer! There are no user serviceable parts inside! Repair should be done by authorized service personnel! (refer to page 25) table of contents warnings ......................................................................

  • Page 3: User Notices

    3 user notices carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels by visiting our web site at www.Bunn.Com. Introduction the bunn ® m...

  • Page 4: Important Safeguards

    4 important safeguards follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • read all instructions. • do not touch hot surfaces. Use handles or knobs. • to protect against electric shock, do not place cord, plug, o...

  • Page 5: General Information

    5 • use caution when dispensing hot water from the brewer. The water from your bunn ® pod brewer is approximately 200°f (93°c). This is approximately 50°f (10°c) hotter than the hot water from your faucet and must be handled with care. • this brewer is designed to remain plugged in at all times (exc...

  • Page 6: Features & Controls

    6 fig 1. Exploded view fig 2. Control panel water reservoir slide lid pod holder release button pod holder insert pod holder drip tray grate drip tray power switch control panel volume control slide lever heating indicator refill water indicator pod holder indicator coffee brew button* tea brew butt...

  • Page 7: Definitions

    7 definitions components • water reservoir - holds reserve water for brewing. The reservoir can be removed and filled separately at a sink or other clean water source or by pouring water through the slide lid. (holds 46 oz. (1.7 l) to the maximum line.) • slide lid - the slide lid allows access to th...

  • Page 8: Features

    8 • pod holder indicator - this indicator identifies a missing or unlocked pod holder. Before a brew cycle can be started, the pod holder must be inserted and locked into place. • tea brew button - depress this button to brew a serving of tea or coffee. Pressing it again will cancel a brew cycle in p...

  • Page 9: Plumbing Hook-Up

    9 shipping cap strainer/flow control fig 3. Plumbing p3524 plumbing hook-up 1. Attach the 90° tube to the flare inlet fitting on the back of the brewer. 2. Install the strainer/flow control to the inlet tube. Note: ensure the flow arrow depicted on the label of the strainer/flow control is facing toward t...

  • Page 10: “Automatic Section”

    10 “automatic section” initial brewer set-up 1. Remove the lid and water reservoir. (caution: do not place the brewer in a sink or other water source.) 3. Replace the reservoir and lid and close the slide lid. 8. Press and release the coffee brew button to fill the reservoir with water. 4. To ensure ...

  • Page 11

    11 brewing delicious coffee or tea 1. Adjust the volume control lever to the desired volume. Note: minimum volume is approx. 4 oz. (118 ml) maximum is approx. 12 oz. (355 ml) settings are in 1 oz. (30 ml) 2. Place a mug, larger than the volume selected, on the drip tray grate below the pod holder . ...

  • Page 12: “Pour-Over Section”

    12 “pour-over section” initial brewer set-up 1. Remove the lid and water reservoir. (caution: do not place the brewer in a sink or other water source.) 8. Place a mug or bowl that will hold at least 14 fl. Oz. (414 ml) onto the drip tray grate. 4. Replace the reservoir and lid and close the slide lid...

  • Page 13

    13 brewing delicious coffee or tea 1. Open the slide lid. (caution: do not place brewer in sink or other water source.) 2. Fill the reservoir above the minimum line, up to the maximum line with fresh cold water. 3. Close the slide lid. 4. Adjust the volume control lever to the desired volume. Note: ...

  • Page 14: Hot Water

    14 hot water the same basic steps used to brew coffee or tea can be used to obtain hot water by leaving the coffee pod or tea bag/pod out of the pod holder. Caution: the water from your bunn ® pod brewer is approximately 200°f (93°c). This is hotter than the hot water from your faucet and must be ha...

  • Page 15: Water Quality

    15 water quality install a water conditioner if your water contains excessive amounts of sediment, taste, or odors. Golden cup standard you might find it interesting that the specialty coffee association of america (scaa), has established standards for the perfect serving of coffee, or golden cup sta...

  • Page 16: Routine  Cleaning

    16 routine cleaning before beginning any cleaning procedure, unplug the brewer to avoid the accidental start of a brew cycle. Clean the pod holder, drip tray and drip tray grate after each use, using a damp cloth and mild detergent and rinse. With the pod holder and drip tray removed, use a damp clo...

  • Page 17: Cleaning The Sprayhead/seal

    17 8) when the cycle has finished, empty the container. Repeat step 7 at least two more times to remove the solution from the tank. 9) clean the pod holder with a mild detergent and rinse thoroughly. 10) proceed to the “cleaning the sprayhead/seal” section. Cleaning the sprayhead/seal 1) press the po...

  • Page 18: Cleaning The Pod Holder

    18 inspecting the sprayhead seal when disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal should last for an extended period of time, damage can occur through handling. Caution: the seal confines the hot liquid to the pod holder. Replace t...

  • Page 19: Troubleshooting

    19 troubleshooting situation explanation nothing happens when the coffee button or tea button is pressed. This is the first time you have used your brewer. The initial brewer set-up procedure must be performed first. Please follow the directions on page 10 (automatic) or page 12 (pour- over) before at...

  • Page 20: Situation

    20 situation explanation the refill water indicator has come on. The pod holder indicator has come on. The water shuts off and comes back on again when brewing. Pour-over only: the water reservoir has run low on water. Slide the lid open and pour additional water into the reservoir, or remove the re...

  • Page 21: Troubleshooting (Cont.)

    21 troubleshooting (cont.) situation explanation (continued) the water shuts off and comes back on again when brewing. The pod holder will not come out of the brewer. Water is appearing on the counter around the base of the brewer. Water leaks out around the sprayhead. Again. This is normal and will...

  • Page 22: Situation

    22 situation explanation the bunn ® (pod holder release button) indicator is not on all of the time. The heating indicator comes on when the coffee or tea button is pressed. The heating indicator comes on during a brew cycle. When the bunn ® button (also known as the pod holder release button) is li...

  • Page 23: Bunn

    23 bunn ® replacement parts sliding lid dishwasher safe. Pod holder dishwasher safe. Water reservoir holds 46 oz. (1.7 l) of fresh water for quick brewing. Dishwasher safe. Drip tray and grate dishwasher safe. Catches up to 6 oz. (177 ml) of liquid. Sprayhead precision jetstream ™ sprayhead for full...

  • Page 24: Limited Warranty

    24 limited warranty bunn-o-matic corporation (“bunn” or “we”) warrants to the original user (the “buyer” or “you”) of this pod brewer that the pod brewer is free from defects in material and workmanship existing at the time of manufacture and appearing within two years of the date of original purcha...

  • Page 25: Authorized Service

    25 authorized service for service information contact: bunn-o-matic corporation 1-800-870-0894 to receive full assistance, please have serial number ready when calling for service. (located on the bottom of your brewer) service center locations: visit our web site at www.Bunn.Com bunn-o-matic corpor...