P2955 model mcp model mca p2896 use and care of your my café ® tea & coffee pod brewer commercial type the bunn logo is a registered trademark of bunn-o-matic corporation. My café is a registered trademark of bunn-o-matic corporation. 37268.0004d 05/08 ©2006 bunn-o-matic corporation model: serial nu...
2 hazardous voltage! Can cause fire or electrical shock! Do not disassemble the brewer! There are no user serviceable parts inside! Repair should be done by authorized service personnel! Table of contents warnings .........................................................................................
3 user notices carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels by visiting our web site at www.Bunn.Com. Introduction the bunn ® m...
4 important safeguards follow these basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury: • read all instructions. • do not touch hot surfaces. Use handles or knobs. • to protect against electric shock, do not place cord, plug, ...
5 • use caution when dispensing hot water from the brewer. The water from your bunn ® pod brewer is approximately 200°f (93°c). This is approximately 50°f (10°c) hotter than the hot water from your faucet and must be handled with care. • this brewer is designed to remain plugged in at all times (exc...
6 fig 1. Exploded view fig 2. Control panel 46 oz. Water reservoir* slide lid* pod holder release button pod holder insert* pod holder* drip tray grate* drip tray* power switch control panel volume control slide lever heating indicator refill water indicator pod holder indicator coffee brew button* ...
7 definitions • sleep mode - if the brewer has been idle for 6 hours, it will reduce power to conserve energy. After 26 hours, the brewer will shut down completely. When either of these two sleep modes occur, the pod holder release button will no longer be glowing red. To wake the brewer up, press e...
8 water inlet set-up (mca only) the my café ® automatic pod brewer is designed for businesses and office applications, where a pressurized water system can be utilized to feed the brewer with a constant water supply. If the machine will not be used with plumbing, proceed to the “pour-over” section o...
9 initial brewer set-up caution: do not place the brewer in a sink or other water source. Caution: you should hear a click when the pod holder locks in place. -turn on power 3. Plug in the brewer and turn on the power switch. P2961 p2965 p0214/2960 -check pod holder 2. To ensure the pod holder is lo...
10 brewing delicious coffee or tea 2. Adjust the volume control lever to the desired volume. Note: minimum volume is approx. 4 oz. (118 ml) maximum is approx. 12 oz. (355 ml) settings are in 1 oz. (30 ml) increments. Volumes are approximate and may vary with type and size of pod. 3. Place a mug, sev...
11 routine cleaning before beginning any cleaning procedure, unplug the brewer to avoid the accidental start of a brew cycle. Clean the pod holder, drip tray and drip tray grate after each use, using a damp cloth and mild detergent and rinse. With the pod holder and drip tray removed, use a damp clo...
12 8) when the cycle has finished, empty the container. Repeat step 7 at least two more times to remove the solution from the tank. 9) clean the pod holder with a mild detergent and rinse thoroughly. 10) proceed to the “cleaning the sprayhead/seal” section. Cleaning the sprayhead/seal 1) press the p...
13 inspecting the sprayhead seal when disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal should last for an extended period of time, damage can occur through handling. Caution: the seal confines the hot liquid to the pod holder. Replace ...
14 troubleshooting situation explanation the refill water indicator has come on. The pod holder indicator has come on. The water shuts off and comes back on again when brewing. Pour-over only: the water reservoir has run low on water. Slide the lid open and pour additional water into the reservoir, ...
15 troubleshooting (cont.) situation explanation (continued) the water shuts off and comes back on again when brewing. The pod holder will not come out of the brewer. Water is appearing on the counter around the base of the brewer. Water leaks out around the sprayhead. Again. This is normal and will...
16 situation explanation the bunn ® (pod holder release button) indicator is not on all of the time. The heating indicator comes on when the coffee or tea button is pressed. The heating indicator comes on during a brew cycle. When the bunn ® button (also known as the pod holder release button) is li...
17 limited warranty bunn-o-matic corporation (“bunn” or “we”) warrants to the original user (the “buyer” or “you”) of this pod brewer that the pod brewer is free from defects in material and workmanship existing at the time of manufacture and appearing within two years of the date of original purcha...
