1. DL manuals
  2. Bunn
  3. Racks & Stands
  4. Single SH
  5. Installation & Operating Manual

Bunn Single SH Installation & Operating Manual

Summary of Single SH

  • Page 1

    Ca ution ! Dual ® sh 1.50 & 1.75 gallon installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the manual or to obtain the illustrated parts catalog, please visi...

  • Page 2

    Page 2 introduction this equipment will brew two 1/2 gallon, 1 gallon and 1-1/2 gallon or 1-3/4 gallon batches of coffee into awaiting serv- ers at the push of a button. The brewer is also equipped with a hot water faucet for allied beverage use and is designed to interface with a bunn ® grinder. Th...

  • Page 3: Main On/off

    Page 3 user notices the notices on this brewer should be kept in good condition. Replace unreadable or damaged labels. 00656.0000 00831.0000 00658.0000 20201.5600 37881.0000 this equipment must be installed to comply with the international plumbing code of the international code council and the food...

  • Page 4

    Page 4 28222 111808 electrical requirements warning - the brewer must be disconnected from the power source until specified in initial set-up. Refer to data plate on the brewer, and local/national electrical codes to determine circuit requirements. 120/208 & 120/240 volt ac models note: this electri...

  • Page 5

    Page 5 plumbing requirements this brewer must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kpa) from a 1 ⁄ 2 " or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the line when pressure is...

  • Page 6

    Page 6 28222 011110 to increase a batch size. Press and hold the start or brew switch until three clicks are heard. Release the switch (failure to release the switch within two seconds after the third click causes the volume setting to be aborted and previous volume setting will remain in memory) an...

  • Page 7

    Page 7 operating controls (cont.) (c) enable brew (on/off switch) placing the switch in the unlighted lower position cuts power to the timer and stops brewing. Stopping a brew cycle after it has been started will not stop the flow of water from the funnel. Placing the switch in the lighted upper pos...