1. DL manuals
  2. Bunn
  3. Coffee Maker
  4. TITAN SINGLE
  5. Installation & Operating Manual

Bunn TITAN SINGLE Installation & Operating Manual

Summary of TITAN SINGLE

  • Page 1

    Titan single™ installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the manual or to obtain the illustrated parts catalog, please visit the bunn-o-matic website...

  • Page 2

    Page 2 introduction this equipment will brew coffee into an awaiting server or airpot. The brewer may have an auxillary hot water faucet. It is only for indoor use on a sturdy and level counter or shelf. Please install in an area where there are no water jet devices. This brewer can be programmed to...

  • Page 3

    Page 3 40885 080108 user notices carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels. #00656.0000 this equipment must be installed to comply with the international plumbing c...

  • Page 4

    Page 4 40885 080108 electrical requirements warning - if the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with a special cord available from the manufacturer or its service agent in order to avoid a hazard. Refer to data plate on the brewer, and local/nati...

  • Page 5

    Page 5 plumbing hook up 1. Remove the shipping cap from the fitting on the rear of the brewer. 2. Attach the flare elbow fitting (supplied separately with the brewer) to the fitting. 3. Flush the water line and securely attach it to the flare elbow fitting. 4. Turn on the water supply. Plumbing requ...

  • Page 6

    Page 6 enable on / off brew small large brew a. Main on/off switch this switch, located under the brewer in front of the right rear leg, turns power on and off to all components in the brewer. B. On/off switch (enable brew) pressing the "on/off" switch will alternately turn the brew components on an...

  • Page 7

    Page 7 initial set-up viewing asset & serial number 1. To view the asset number of the machine, press and hold the left hidden switch until the display reads: anxxxxxx...Asset number. Release the left hidden switch. 2. After a 5 second delay, the display will read: dttnxxxxxx. This is the serial num...

  • Page 8

    Page 8 coffee brewing 1. Begin each brew cycle with a clean empty brew funnel. 2. Insert a bunn filter into the funnel. Note: the funnels are equipped with 4 wire loops that can be folded over top edge of filter if desired, to prevent filter from folding in during the brew cycle. 3. Pour the fresh c...

  • Page 9

    Page 9 cleaning 1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on bunn-o-matic equipment. Do not clean this equipment with a water jet device. 2. Check and clean each sprayhead. The sprayhead holes must always remain open. Note: ...