CAB SQUIX Operator's Manual - page 27
27
7
Fault Correction
7.1
Error Display
The appearance of an error will be shown on the display:
Figure 24
Error display
The error treatment is pending on the error type
7.2 on page 27.
The display offers the following possibilities to continue after an error occurred:
Repeat
The print job will be continued after clearing the error cause.
Cancel
The print job will be cancelled.
Feed
The paper feed will be synchronized. Following the print job can be continued.
Ignore
The error message will be ignored. The print job will be continued possibly with limited
performance.
Save log
The error does not allow print operation.
Fordetailedanalysisseveralsystemfilescanbesavedonanexternalmemory.
Table 5
Button in the error display
7.2
Error Messages and Fault Correction
Error message
Cause
Remedy
Barcode error
Invalid barcode content, e.g. alphanumeric
characters in a numerical barcode
Correct the barcode content.
Barcode too big
The barcode is too big for the allocated
area of the label
Reduce the size of the barcode or move it.
Buffer overflow
The input buffer memory is full and the
computer is still transmitting data.
Use data transmission via protocol (preferably
RTS/CTS).
Cutter blocked
Cutter cannot return into its home position
andstaysinanundefinedposition
Switch off the printer. Remove material. Switch on
the printer. Restart print job.
Change material
No cutter function
Switch the printer off and then on.
If error recurs call service.
Cutter jammed
The cutter is unable to cut the labels but is
able to return into its home position
Press Cancel
Change material.
Device not conn.
Programming addresses a non-existent
device
Either connect this device or correct the
programming.
File not found
Requestedfileisnotonthecard
Check the contents of the card.
Font not found
Error with the selected download font
Cancel current print job, change font.
Memory overflow
Current print job contains too much infor-
mation, e.g. selected font, large graphics
Cancel current print job.
Reduce amount of data to be printed.
Name exists
Duplicateusageoffieldnameinthedirect
programming
Correct programming